How to distribute timecode signals via LYNX modules : LYNX Technik AG

Knowledge base

Welcome to LYNX Technik AG Technical Support. Below you will find our Knowledge Base. You can either browse for an article by reviewing the topic headings, or you can search the Knowledge Base by entering a search term (for example “PVD 5840 AV Delay”….). If you are a registered user and currently logged into the system then you can also search your support tickets in the same way. If the Knowledge Base does not provide the answers you require, then please open a new ticket to submit your specific questions.

How to distribute timecode signals via LYNX modules Print

Modified on: Wed, 5 Jul, 2017 at 1:24 PM

The following LYNX modules can be used for Timecode distribution:

DAA5320
DAA5321

DVA5718-L Analog Video DAmp
DVA5724 Analog Video DAmp
DVA5760-L Analog Video DAmp
Older LYNX analog video distributors with selectable clamping

Important note for DVA57xx / analog video devices:

The signal level must not be above 1V.
Clamping has to be disabled in the APPolo GUI (see below).
If pulse tilt causes problems DC Coupling should be enabled.

Did you find it helpful? Yes No

Knowledge base

How to distribute timecode signals via LYNX modules Print

Related Articles